Performance of a TR-iso-pulse generator in micro ED-drilling

Abstract

This study describes a TR-iso-pulse generator which has better machining performance than an RC-pulse generator in micro-electrical discharge drilling (micro ED-drilling). Although machining with a TR-pulse generator is more efficient compared to when using a RC-pulse generator in macro-scale EDM, an RC-pulse generator is mainly used in micro EDM because it can generate the short discharge pulse necessary to minimize the discharge energy. However, to increase the machining efficiency, it is necessary to develop a TR-iso-pulse generator capable of generating a small amount of uniform discharge energy. In this research, a TR-iso-pulse generator was constructed for micro ED-drilling. For an accurate performance comparison between an RC-pulse generator and a TR-iso-pulse generator, each pulse generator was set up to generate the same discharge energy for a single discharge. Through micro ED-drilling, material removal rate (MRR) and relative wear ratio (RWR) were measured with respect to feed rate, and surface roughness was also measured with a 3D profiler. As a result, MRR increased by 121% and RWR decreased by 39% in the TR-iso-pulse generator compared with the RC-pulse generator. Surface roughness also reduced by 22% in the TR-iso-pulse generator.