Publications
Detailed Information
Effects of the acetone content of single solution dentin bonding agents on the adhesive layer thickness and the microtensile bond strength
DC Field | Value | Language |
---|---|---|
dc.contributor.author | Cho, Byeong-Hoon | - |
dc.contributor.author | Dickens, Sabine H | - |
dc.date.accessioned | 2010-01-28T01:32:43Z | - |
dc.date.available | 2010-01-28T01:32:43Z | - |
dc.date.issued | 2004-02 | - |
dc.identifier.citation | DENTAL MATERIALS 2004;20:107-115. | en |
dc.identifier.issn | 0109-5641 | - |
dc.identifier.uri | https://hdl.handle.net/10371/45974 | - |
dc.description.abstract | Objectives. This study investigated the hypothesis that varying the acetone
content of single solution dentin bonding agents may affect the adhesive layer thickness and microtensile bond strength (MTBS) of the bonded complex, and explored whether the adhesive layer thickness is a valid predictor for MTBS. Methods. Experimental dentin bonding agents containing (27, 37, 47, 57, or 67) mass fraction% acetone were used to bond composite resin onto occlusal dentin surfaces of extracted human molars. The adhesive layer thickness was determined by digitized image analysis. MTBS was measured after 48 h. The fracture surfaces were observed using SEM. Results. With increasing acetone content, MTBS varied from 38 MPa (67% acetone) to the highest MTBS of 64 MPa (37% acetone), while the adhesive layer thickness decreased linearly. Both dependent variables demonstrated moderate inverse correlation with the acetone content ðp , 0:0001Þ; but were not correlated with each other ðp . 0:05Þ: Ninety-four percent of the specimens showed fractures within the adhesive layer extending toward the interfaces with the hybrid layer or the composite resin. In the groups containing 57 and 67% acetone, cracks were observed at these interfaces. Significance. Rather than the adhesive layer thickness, interfacial cracks in specimens with acetone-rich bonding agents may have caused lower MTBS. Within the scope of this investigation, lower acetone concentrations, as could be anticipated from solvent evaporation during clinical use of the bonding agent, did not seem to lower MTBS, but rather improved the integrity of the dentin/adhesive bond. Published by Elsevier Ltd. on behalf of Academy of Dental Materials. | en |
dc.language.iso | en | en |
dc.publisher | Elsevier | en |
dc.subject | Acetone concentration | en |
dc.subject | Adhesive layer thickness | en |
dc.subject | Microtensile bond strength | en |
dc.subject | Single solution dentin bonding agents | en |
dc.subject | Crack formation | en |
dc.subject | Failure mode | en |
dc.title | Effects of the acetone content of single solution dentin bonding agents on the adhesive layer thickness and the microtensile bond strength | en |
dc.type | Article | en |
dc.contributor.AlternativeAuthor | 조병훈 | - |
- Appears in Collections:
- Files in This Item:
- There are no files associated with this item.
Item View & Download Count
Items in S-Space are protected by copyright, with all rights reserved, unless otherwise indicated.