Publications

Detailed Information

반복 하중이 Full veneer crown의 유지력에 미치는 영향에 관한 연구 : The effect of cyclic loading on the retentive strength of full veneer crowns

Cited 0 time in Web of Science Cited 0 time in Scopus
Authors

김기연; 이선형; 정헌영; 양재호; 허성주

Issue Date
2000
Publisher
대한치과보철학회
Citation
대한치과보철학회지 2000;38:583-594
Keywords
Cyclic loadingTaperLuting cementRetentive strength
Abstract
Dislodgement of a crown or extension bridge and the loosening of a retainer of a bridge is a serious clinical problem in fixed restoration. Generally these problems are considered to be associated with deformation of the restoration. During biting, the restoration is subjected to complex forces and deforms considerably within the limit of its elasticity. Deformation of the restoration under the occlusal force induces excessive stress in the cement film, which then leads to the cement fracture. Such a fracture may eventually cause loss of the restoration. Because most of the past retention tests for full veneer crown were done without fatigue loading, they were not exactly simulating intraoral environment. And the purpose of this study was to evaluate the effect of cyclic cantilever loading on the retentive strength of full veneer crowns depending on different type of cements and taper of prepared abutment. Steel dies with convergence angle were fabricated through milling and crowns with the same method. These dies and crowns were divided into 8 groups. Group 1 : taper die, cementation with zinc phosphate cement, without loading Group 2 : taper die, cementation with zinc phosphate cement, with loading Group 3 : taper die, cementation with zinc phosphate cement, without loading Group 4 : taper die, cementation with zinc phosphate cement, with loading Group 5 : taper die, cementation with Panavia 21, without loading Group 6 : taper die, cementation with Panavia 21, with loading Group 7 : taper die, cementation with Panavia 21 without loading Group 8 : taper die, cementation with Panavia 21, with loading After checking the fit of die and crown, the luting surface of dies and inner surface of crowns were air-abraded for 10 seconds. The crowns were cemented to the dies, with cements mixed according to the manufacturer's recommendations. A static load of 5kg was then applied for 10 minutes with static loading device. Twenty-four hours later, group 1, 3, 5, 7 were only thermocycled, group 2, 4, 6, 8 were subjected to cyclic loading after thermocycling. Retentive tests were performed on the Instron machine. From the finding of this study, the following conclusions were obtained 1. Panavia 21 showed significantly higher retentive strength than zinc phosphate cement for all groups (p<0.05). 2. There was a significant difference in the retentive strength between taper for zinc phosphate cement(p<0.05), but no significant difference for Panavia 21 (p>0.05). 3. Cyclic loading significantly decreased the retentive strength for all groups(p<0.05). 4. For zinc phosphate cement, there was 35% reduction of the retentive strength after loading in the taper die, 25% in the taper die, and for Panavia 21, 21% in the taper die, 18% in the taper die.
ISSN
0301-2875
Language
Korean
URI
http://uci.or.kr/G100:I100-KOI(KISTI1.1003/JNL.JAKO200024718498913)

https://hdl.handle.net/10371/37659
Files in This Item:
Appears in Collections:

Altmetrics

Item View & Download Count

  • mendeley

Items in S-Space are protected by copyright, with all rights reserved, unless otherwise indicated.

Share